/*
- Copyright (C) 2016-2017 Carl Hetherington <cth@carlh.net>
+ Copyright (C) 2016-2018 Carl Hetherington <cth@carlh.net>
This file is part of DCP-o-matic.
#include "content.h"
#include "video_content.h"
#include "subtitle_content.h"
+#include "audio_processor.h"
#include "font.h"
#include "ratio.h"
#include "audio_analysis.h"
hints.push_back (_("Your DCP has fewer than 6 audio channels. This may cause problems on some projectors."));
}
+ AudioProcessor const * ap = film->audio_processor();
+ if (ap && (ap->id() == "stereo-5.1-upmix-a" || ap->id() == "stereo-5.1-upmix-b")) {
+ hints.push_back (_("You are using DCP-o-matic's stereo-to-5.1 upmixer. This is experimental and may result in poor-quality audio. If you continue, you should listen to the resulting DCP in a cinema to make sure that it sounds good."));
+ }
+
int flat_or_narrower = 0;
int scope = 0;
BOOST_FOREACH (shared_ptr<const Content> i, content) {
Ratio const * r = i->video->scale().ratio ();
if (r && r->id() == "239") {
++scope;
- } else if (r && r->id() != "239" && r->id() != "full-frame") {
+ } else if (r && r->id() != "239" && r->id() != "190") {
++flat_or_narrower;
}
}
hints.push_back (_("All of your content is at 1.85:1 or narrower but your DCP's container is Scope (2.39:1). This will pillar-box your content inside a Flat (1.85:1) frame. You may prefer to set your DCP's container to Flat (1.85:1) in the \"DCP\" tab."));
}
- if (film_container != "185" && film_container != "239" && film_container != "full-frame") {
+ if (film_container != "185" && film_container != "239" && film_container != "190") {
hints.push_back (_("Your DCP uses an unusual container ratio. This may cause problems on some projectors. If possible, use Flat or Scope for the DCP container ratio"));
}
string h;
if (range.second > (29.0/24)) {
h = base;
- h += _("However, setting your DCP frame rate to 24 or 48 will cause a significant speed-up of your content, and SMPTE DCPs are not be supported by all projectors.");
+ h += _("However, setting your DCP frame rate to 24 or 48 will cause a significant speed-up of your content, and SMPTE DCPs are not supported by all projectors.");
} else if (range.first < (24.0/29)) {
h = base;
h += _("However, setting your DCP frame rate to 24 or 48 will cause a significant slowdown of your content, and SMPTE DCPs are not supported by all projectors.");